Another Salamander, this one with a yellow poplar top with a gouged surface, on a buckeye back with a hammered and antiqued finish.
Neck is walnut, with an osage orange fretboard.
.82″ thick at 1st fret, .93″ at 12th. 1.68″ nut width.
Pickups are homespun humbuckers with alnico 5 polepieces, in aluminum casings.
Bridge~ 5400 turns per coil, 8Kohms DCR
Neck~ 4800 turns per coil, 6.8Kohms DCR
Brass compensated bridge/tailpiece combo and Hipshot classic tuners.
Weighs 6.5 pounds
Another Salamander, this time with an eastern red cedar top on a basswood back.
I initially did the same gouged surfacing as on the walnut one, but wasn’t happy with how it turned out on the cedar, so I sanded it down and just did a mildly distressed finish, which suits it much better.
The neck is maple, with an osage orange fretboard.
Pickups are my homespun humbuckers, but my standard windings ended up sounding overly bright and harsh in this one, compared to the walnut version with the walnut neck and persimmon fretboard, so i made a set of overwound ones, which sound much fuller and less brash.
Bridge pickup: 7200 turns per coil, 10.6K ohms DCR
Neck pickup: 5600 turns per coil, 8.2K ohms DCR
Both have alnico 5 rod polepieces and aluminum casings.
Brass compensated bridge/tailpiece combo.
Hipshot Classic tuners.
Weighs 6.6 pounds.
Further evolution of the Salamander design, featuring a carved walnut top, surfaced with a gouge to give a hand-hewn look, on a contoured basswood back.
Very sleek and comfortable.
Neck is walnut, with a persimmon fretboard.
Homespun humbuckers with alnico 5 polepieces.
Bridge~ 6000 turns per coil, 8.7K ohms DCR
Neck~ 5000 turns per coil, 7.5K ohms DCR
Aluminum compensated bridge/tailpiece with locking studs.
Hipshot Classic open-gear tuners.
25″ scale, 22 high/wide frets
Weighs 6.8 pounds